The Colony Concrete Lifting logoThe Colony Concrete LiftingThe Colony, TX
Foundation Void Filling & Soil Stabilization photo

The Colony Concrete Lifting

Void Filling and Soil Stabilization in The Colony, TX

Void filling and soil stabilization in The Colony: injection to restore soil support and reduce repeat slab settling, free estimates.

  • 15+ Years local experience
  • 500+ Projects completed
  • Licensed & Insured

Serving The Colony and nearby communities.

Denton County clay doesn't settle once and stop. It shrinks and swells with every dry stretch and every rain, and each cycle can open a fresh void under a slab that was already lifted once. Void filling and soil stabilization goes after that root cause instead of just lifting the concrete again.

Near Lewisville Lake, a shifting water table adds a second variable, washing out supporting soil under patios and pool decks over time. The Colony Concrete Lifting maps the extent of the void first, then injects a stabilizing material meant to restore support, not just fill a gap.

What's included

What's included with Void Filling and Soil Stabilization

Typically included: Optional: Customer prep:

  • Void mapping across the affected slab area
  • Stabilizing foam injection to restore soil support
  • Confirmation check that support is restored beneath the slab
  • Hole patching once injection is complete
  • Bundled lifting of the affected slab in the same visit
  • Point out any areas with a history of repeat settling

How it works

How our Void Filling and Soil Stabilization process works

  1. Access drilling photo
    Step 1

    Site inspection

    Identify areas with hollow or soft spots.

  2. Void mapping photo
    Step 2

    Void mapping

    Extent of the gap traced across the slab.

  3. Injection photo
    Step 3

    Stabilizing injection

    Foam placed to restore soil support.

  4. Support confirmation photo
    Step 4

    Support confirmation

    Check for firm base beneath slab.

  5. Follow-up check photo
    Step 5

    Hole patching

    Injection points sealed and finished.

  6. Final check photo
    Step 6

    Final check

    Verify stability before leaving the site.

Timeline

How long does a Void Filling and Soil Stabilization take?

  1. 01

    Stage 1

    This service is usually paired with a lift, not run on its own.

  2. 02

    Free estimate

    same day
  3. 03

    Scheduling

    within the week

  4. 04

    Injection and stabilization

    two to four hours, same visit as lifting

Need a schedule that fits?

Get a Free Estimate

Next step

Ready for use**: same day

FAQs

Void Filling and Soil Stabilization FAQs

How to raise concrete that has settled repeatedly in the same spot?

Repeat settling usually means the original void was never fully addressed. Filling and stabilizing the soil beneath the slab, not just lifting the concrete again, gives the fix a better shot at holding.

Will lifted concrete sink again after a rainy season?

It can, if the void underneath wasn't fully stabilized the first time. Filling that gap with a stabilizing material resists the push and pull of wet-dry cycles better than an unfilled void left behind by a lift alone.

Do I need a permit for soil stabilization work?

Void filling under an existing driveway or patio usually doesn't need one. Larger stabilization projects tied to structural areas may, so it's worth checking with the city if the scope grows.

How much does void filling cost?

Cost depends on the size of the void, the soil condition, and how much area is affected. A free estimate gives a specific range for your property.

Ask about Void Filling and Soil Stabilization

Tell us about the project and how to reach you.

Call (254) 364-6474